MakeTheOne Old School Style Bike Speedometer in KPH Analog Odometer Classic Style for 24”-27.5” Bicycle

With so many reviews lots of great ones and some not so good, I thought I shared my findings ordered I ordered two of them one my bike and wife's I tested them on the wok table and one did seem tighter to tun than the other . What I did was used my 3 in 1 oil on both and they both spun freely (very freely) put on normal and work perfect so, my suggesting is oil everything the bottom part where the spokes turn then the cable then the speedo with 3 in 1 oil and your good to go! so you know the bottom gears are plastic and need the oil or probably why some had no problem once it wears in.. or others that had problems.

Kids love this it motivate them to ride far and fast

It took me 4 hours to get the thing installed. I'd put it on and it wouldn't work. Try it again and again. Nothing. Finally after two hours I got it working except it ran backwards. At that point I seriously considered just exercising backwards. I then decided to try and correct it and ended up on another two hour journey. At that point the thing broke in two places and I had to duct tape part of it and glue another. I finally got it on the bike and running correctly...so far. I'm sure it will probably just bust again tonight when I try to use it for real. But two stars for now because now that I got it working, it does work. Update: As predicted, it fell apart after a few days of use. I'm going to request a refund and change my review from two stars to one star.

I was amazed how fast I was going!!! As a person who grew up with damage meters in world of Warcraft, I had to replace my broken speedometer so I can see how fast I am going. I did not notice until I read a comment about it a few days later lol. But no biggie as I installed it on our old roadmaster 240 stationary bike. It was easy to install, had to push in the line and screw it in tightly to make the speedometer to actually work. **if yours in not working just push it in more and screw it tighter on both ends**

Slight modification needed to mount the actuator/rotator to the wheel axle

Takes less than 10 min to install on bike...love the old school look it gives to my electric converted bike.

I liked how easy it was to install. I put it on a gas powered motorized bicycle and I had to replace the metal piece that spins around with the wheel once but that was after about 700km on the odometer. I’ve dropped the bike on its side and crashed it with the speedometer on it and it still works so it’s pretty tough other than it being scratched up from hitting the road.

Speedometer works ... don't know whether it is accurate or not, just remember it is in kilometers per hour. No issues with speedometer or cable. The worm gear is another story ... I purchased the item to scavenge parts to repair an old Schwinn AirDyne. Manufacturer please note: tolerance between the worm gear and worm is too tight making the unit difficult to turn. If you go in reverse, the gears do not mesh properly and the unit comes apart (Worm gear, seal, drive tang and lock ring, pop off the housing.) Fortunately you can pop it back in. The retaining lip on the housing is almost non-existent allowing the unit to easily come apart. (Old Schwinn unit had a definite groove allowing the seal to SNAP into place keeping the unit from falling apart. Swapped out the worm gear with the old one ... turns smoothly now). Don't know how long the unit will last, but it was an inexpensive solution. Note: if you tighten the cable to the wormgear housing too tightly, the inside cable will not spin properly.

Works perfect, no issues with the product.

Mein Mann war begeistert

Easy enough to mount and I put it on a 700 wheel so though it might be reading slightly off it does give me a pretty good idea of how fast I am pedalling and it looks pretty awesome on my classic Dutch bike.